master warning

master warning

NewsGroups | Search | About
 rec.aviation.simulators    Post an article   get this group's latest topics as an RSS feed add this group's latest topics to your My MSN content add this group's latest topics to your My Yahoo content add this group's latest topics to your Google content
Subject Author Date
master warning Kevin 07-27-2006
Posted by Kevin on July 27, 2006, 10:50 am
Please log in for more thread options
Hello all,
As I begin to figure out how to fly the A321 jet, I have encountered a
significant problem. As I reach 30,000 feet, my master warning sign
comes on. I have low oil pressure and my N1 remains at 92%. At the
same time, my airspeed drops to ~110. I believe it has something to do
with the cowlflaps, but I am not sure. If it is indeed thecowl flaps,
how do I adjust them in x-plane. If not, any suggestions?


Posted by RobertVA on July 27, 2006, 2:28 pm
Please log in for more thread options
Kevin wrote:
show/hide quoted text

Using the altitude hold on the autopilot? If so what is the climb rate
set to? What is your fuel level? Did you have the throttles set for
maximum all the way to 30,000?

An aircraft can't maintain the same indicated airspeed with a high climb
rate at high altitudes. It's necessary to reduce the climb rate
significantly as you approach cruise altitude.

Many aircraft can't reach their normal cruise altitude immediately after
takeoff with a full fuel load. If the flight duration requires that much
fuel the plane has to cruise at a lower altitude for a while until fuel
consumption reduces its gross weight. If the autopilot increases the
angle of attack enough while attempting to climb with too much weight
there MIGHT be some effect on airflow into the engines.

There are sometimes limitations on the time jet and other turbine
engines should be operated at maximum throttle settings. The operating
procedures might call for some large fraction of maximum throttle after
the first few minutes in flight. There may be some simulator aircraft
models that imitate the malfunctions that could result from prolonged
operation at maximum throttle.

Posted by Guy on July 28, 2006, 4:33 am
Please log in for more thread options
Above FL250 you have to set the speed in Mac number, otherwise it will
stall, due to little air above that FL.
You will then notice the IAS going down as you climb further up,but the
plane will keep the MAC nr.as commanded.

show/hide quoted text




other useful resources:
NASA - National Aeronautics and Space Administration
Kennedy Space Center
European Space Agency
China National Space Administration
Russian Space Research Institute
Canadian Space Agency

Air-Space.us XML SitemapXML Sitemap

Contact Us | Privacy Policy